skip to Main Content

Kepez Intermediate Filler

Kepez Intermediate Filler

Extensible compression resistant can arise from temperature changes elastic construction material, intended for filling and leveling spaces and pores remaining between these plates that after installation of ceramic, tile, marble, granite, natural stone panels

Application areas

Interior and exterior spaces

Vertical and horizontal locations

For plastering between each kind of flooring boards mounted with binders

Preparation of the place to be used

Ceramic, tile, granite and so on. it is important that the solutions used in the adhesion are well consolidated. The surfaces (plates breaks) should be cleaned and moistened before applying the intermediate filler.

Mixing

7 liters of water is discharged into a clean container. All of the substance in the sack is poured over and the solution is mixed until homogeneous. After approximately 5-10 minutes, wait for the mixture mixed again and the material is ready. The finished product should be used for 2 hours at +20 ̊C. In this case, if the solution is dried additional water can be poured.

How to use

It is spread on the surfaces such as ceramic, granite, etc. with rubber trowel and intervals are filled. Pull out the remaining solution on the surface of the panels with special tools and, at the same time, make sure that the form is not damaged. After about 45-50 minutes, wipe the substrate in the form of a thin layer that will remain on the surface with a soft cloth. When cleaning, spray the sponge in your hand often, so that it is not difficult to remove the stains on the plaque later. The entire surface is cleaned with a sponge and washed again with water. This is done to balance the heat. After 24 hours boards are cleaned with a dry, clean cloth. The expiration date is 24-48 hours after completion of the filling procedure.

Shelf life

For 12 months in unopened packaging

Storage conditions in the storehouse  

Up to 10 pieces may be collected on top of each other in non-moist and dry places

Cleaning tools

Wash the tools with water after finishing work

Security measures

Make sure that this item does not come into contact with your eyes, mouth or skin during use and storage. If the item touches your skin and eyes, rinse with water to clean it up.

Technical features

Resistance to torsion: ≥ 2.5 N / mm

Compression resistance: ≥ 15 N / mm

Abrasion resistance: ≤ 1000 mm

Shrinkage: ≤ 3 mm / m

Water absorption: 30 min / 4 hours ≤ 5 gram / ≤ 10 grams

Heat Resistance: (-30 ̊C) – (+80 ̊C)

 

Back To Top