Kepez Tile and Ceramic Adhesive
Kepez Tile and Ceramic Adhesive is a cement based construction material with high adhesion capability designed for the installation of tile, ceramic tile, ceramic and decorative stones used in the interior and exterior
Application areas
Interior and exterior spaces
To cover roughness on walls, floors and ceilings, to install ceramic tiles, decorative stones
Can be easily used in kitchen, bathroom, corridors, pools and so on.
Advantages
Preparation and use are easy, it is only mixed with water and ready for use
Freezing duration is long
There is no sliding of the tiles during installation
It has high adhesionability and durability for a long time
A special ingredient is added to prevent the formation of cracks in frosty weather conditions
It is produced on the basis of high quality 500 cement branded
Surface preparation
The area to be applied should be dustless, clean and flat. Surface should be cleaned from obstacles that weaken adhesion. If the surface temperature is above 20 ̊C, the surface should be absolutely moistened.
Mixing
The indicated amount of water is filled in pure containers. The sack is opened, the powder-forming Kepez adhesive is added to the water and the solution is stirred until it is homogeneous for 3-4 minutes at 400-600 rpm. After 3 minutes of interruption, it is again mixed for 1 minute and ready for use.
Mixture ratio
Mix of 270 grams of water mixture for 1 kg of Kepez Tile and Tile Adhesive is 1,60 kg / liter.
Application procedure
Application Procedure It is applied to the surface with 1 mm thickness on the flat side of the trowel, before it dries, this solution is applied with notched side of the trowel in the same form, and immediately begins the adhesion process.
It is recommended to apply a 1 mm thick Kepez Tile and Ceramic Tile Adhesive with the straight side of the trowel on the adhesive side of the material with a width of 15 cm and thickness of 6 mm (tile, ceramic tile, etc.).
It is important to apply this method, especially in outer spaces where temperatures are high. By this kind of application,the adhesive of the material to be used will be completely closed by mix.
Packaging
Kepez Tile and Ceramic Adhesive is packaged in 25kg polyethylene paper sacks.
Consumption
The product’s consumption can range from 3.5 kg / m2 to 6 kg / m2, depending on the notched thickness of trowel.
Technical features
Physical appearance – Gray
The amount of the composition of units: not more than 0.5 mm
Density: Approximately 1.6 kg / dm3
Adhesion resistance:> 0.5 N / mm2
Using temperature: +5 ̊ C – +30 C ̊
Intermediate filler time: 24 hours
Use thickness: 3-6 mm
Duration of use in mixed case: 2 hours
The validity period in the surface: min. 20 minutes